Mail us
contact@tiger-transformer.comPhone us
(+86）15655168738
1. Direct start of squirrel cage motor1. Contactor self-locking and overload protection1)Close the power switch QS, press the start button SB2, the AC contactor KM is energized, its main contact is closed, the power is turned on, and the motor starts.2) Release the start button SB2, the control circ
Read More
A stepping motor is a motor that converts electrical pulse signals into corresponding angular or linear displacements.Every time a pulse signal is input, the rotor rotates an angle or advances one step, the output angular displacement or linear displacement is proportional to the number of input pul
Read More
Strong species of prairie side 6W switching power supply chip U6215 With the 618 promotion activities in full swing, chip merchants are also eager to move. Since you want to choose a switching power supply chip, what brand and model is your truly safe and convenient one-step choice?
Read More
1. Definition of switching power supply After the input AC voltage (AC) is rectified and filtered, a high-voltage DC voltage (DC=1.4AC) can be obtained. This voltage is connected to the switching element and used as a switch in 20KHZ~100KHZ high frequency state. At this time, the DC h
Read More
The flyback switching power supply is mostly used in the low and medium power range, such as 2w~100w. Basic principle of flyback power supply When the power supply is in a steady state, at the time ton, the MOS transistor Q1 is turned on, and the inductor current of the prima
Read More
The difference between the continuous mode CCM and the discontinuous mode DCM of the flyback switching power supply is mainly reflected in the transformer design. This article expands to explain which technical parameters of the flyback power supply will be affected by DCM. If you wan
Read More
Combined with the schematic diagram, I try to explain the switching waveforms of the voltage and current at each key point of the flyback switching power supply in the steady state of the discontinuous mode DCM, without involving the specific component parameter values.Basic working principle of fly
Read More
When the MOS tube of the flyback switching power supply is turned off, the energy stored in the leakage inductance of the primary winding of the transformer cannot be transferred to the secondary winding, and the leakage inductance of the primary winding and the parasitic capacitance of the MOS tube
Read More
Type of output diodeSecondary winding output diode D1 usually chooses a Schottky diode or an ultra-fast recovery diode, one is because the reverse recovery time trr of these two diodes is short, and the other is because the forward voltage Vf drop of these two diodes is small.If the diode reverse re
Read More
1. Definition of switching power supplyAfter the input AC voltage (AC) is rectified and filtered, a high-voltage DC voltage (DC=1.4AC) can be obtained. This voltage is connected to the switching element and used as a switch in 20KHZ~100KHZ high frequency state. At this time, the DC high voltage will
Read More
Simple working schematic diagram of the most basic flyback transformer switching power supply. In this circuit system, Ui is the input voltage of the switching power supply, T is the switching transformer, K is the control switch, C is the energy storage filter capacitor, and R is the load resist
Read More
1. EMI regulations and test specifications Full electromagnetic compatibility means that the equipment or system meets the requirements in its electromagnetic environment and does not cause any equipment in its environment Capability of intolerable electromagnetic interference. Table
Read More
